Need some torque specs for my SYE install!

Diablo · 10-02-2002, 03:54 PM

Need torque specs for following:

- rear upper control arms

- front & rear drive shafts

-Thanks

Seth_TJ · 10-02-2002, 04:30 PM

rear upper arms put them on like 55 ft lbs I think
I just crank em down good

front yoke is 90-130 ft lbs, that is a one time use nut or so they say, use the new one, so they say... the nut is not perfectly round so it's gotta catch on there to get started then run it on

output yoke I think I did like 130 or 150 can't remember

10-02-2002, 03:54 PM	#1
Diablo Registered Join Date: May 2002 Posts: 161 Thanks: 0 Thanked 0 Times in 0 Posts	Need some torque specs for my SYE install! Need torque specs for following: - rear upper control arms - front & rear drive shafts -Thanks __________________ NEJEEP.ORG 02' TJ 4.0L Full Traction 6" LA, 35 MT/R's, HP30, Currie HP 9" Chromo Shafts, Locked ARB's Front & Rear, 4.56's, Warn X8000i

10-02-2002, 04:30 PM	#2
Seth_TJ Registered Join Date: Jul 2000 Posts: 4,338 Thanks: 0 Thanked 0 Times in 0 Posts	rear upper arms put them on like 55 ft lbs I think I just crank em down good front yoke is 90-130 ft lbs, that is a one time use nut or so they say, use the new one, so they say... the nut is not perfectly round so it's gotta catch on there to get started then run it on output yoke I think I did like 130 or 150 can't remember __________________ 1997 Red TJ SE 2.5L, AX-5, D30/D35, 4.88's, Dual True-Tracs, Teraflex S3T, 33x10.50 BFG MT K/M, AA SYE/Woods CV, RE Uppers, Canyons, JKS BPE's, Dual RE Trackbars, Kilby Tank Skid, Carsound Cat, Flowmaster 50 Delta Flow, +AMA A/C , etc...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode