PDA

View Full Version : proportioning valve


81cj74x4
10-24-2007, 11:34 PM
i have a proportioning valve from a 91 yj and i need to know what lines go where on it. there are 2 places in the top 2 on the bottom and one on the left side. so if there is any info that you guys have that could help me it would be great. thanks.

TERIOD
10-25-2007, 12:49 AM
in that picture the valve is upside down, the electrical connection goes on top, if it doesnt look like your old valve, then you probably dont want to use it

Janster
10-25-2007, 02:21 AM
I know you've seen this before...

This is actually a ZJ prop installed on my yj -but it'll give you the same info you're looking for.
http://www.lieblweb.com/TechLinks/YJBrakeUpgrades/NewProp.MINI.jpg

Just ran outside to route the lines so I could tell ya where they go...it's 1am so please pardon - hopefully someone can verify this:
Looking at the picture:

Upper RIGHT - Line to Master cylinder FRONT resevoir (large resevoir)
Upper Middle - electric sensor thingy
Upper Left - Line to Master cylinder REAR resevoir (smaller resevoir)

Off the Right side - is I believe drivers side front line.
Lower Right - is I believe passenger side front line.
Lower Left - is I believe the rear line (only one).

Not sure what that other thing on the left side is....