Toyota pull handle e-brake set up. Anybody Got One??

[jmichel62]

I have a 1994 YJ. Putting in a role cage which is getting in the way of the e-brake.

Has anybody put in a Toyota pull handle e-brake?

If so pics would be great..

[love24wheel]

Talk to Ratherbejeeping on this board.. he runs a toy 8" rear axle and is plannin on doing the toy ebrake handle setup, and he may have some ideas on it..
Scott

[RatherBeJeeping]

Like Scott said, I've got one but I haven't installed it yet. Still sorting out what I want to do about A/C first.

To put it in I'll be cutting off the mounting bracket and reversing it to mate up to the bottom of my dash. The firewall gets 3 holes, one for the cable and two for the mounting bolts.

It's a sandwhiched plate set up with a pulley in the engine bad to redirect the cable.

Routing it past the trans, t-case, driveshafts, etc is the only question... and that determines where in the cab to mount the handle. Since I have equal length e-brake cables I'll be looking to run it in the center of the Jeep and use the stock YJ e-brake cable distribution block to capture the 2 cables from the rear.

That the kind of info you were looking for?

[jmichel62]

Yea that is what Im looking for. Will probable be putting mine in next week. Picking up the T Handle soon. Will try and take pics along the way. Not sure why you are putting one in, but I am putting in a roll cage and its making it difficult to get to the foot pedal.
Thinking of mounting it left of the steering wheel and utilizing the same holes as the OEM brake line. Will probable have to make a bracket of some sort.

Ill let you know how it goes.