Power Brake Booster - how hard to replace??

[jeep94wrangler]

I'll be picking up my power brake booster tomorrow from the auto parts store.. mine's shot. Just wanted to see if anyone has replaced this before, if so how long did it take and was it a fairly straight forward job? I looked at it today and I don't anticipate a hard job..
Thanks,
John
:beerchug:

[red89yj]

BTT- i need to do this too

[jeep94wrangler]

Just finished mine. Didn't take more than 45 minutes. Pretty straightforward...
1) Unlatch airbox and lift out of the way.
2) Remove nuts that hold master cylinder to brake booster and pull master cylinder out of the way.
3) Remove 4 nuts on back of brake booster that hold it to the bracket.
4) Under the dash, remove pin that holds brake booster shaft to the brake pedal, and pull shaft off the knob that holds it to the brake pedal.
5) Under the hood, remove the entire brake booster assembly.
6) Reinstall new brake booster (after taking the old one out you will know exactly how to put everything back together, there's just 6 nuts and one pin)
Good luck,
Let me know if you run into any probs